Journal of Iranian Dental Association
J Iran Dent Assoc
Medical Sciences
http://jida.ir
23
journal23
2383-3041
10.52547/jida
en
jalali
1384
4
1
gregorian
2005
7
1
17
4
online
1
fulltext
fa
مقایسه نحوه انتشار نیروها بین سه نوع اتچمنت Bar، Ball و Zaag در اوردنچرهای متکی بر ایمپلنت در فک پایین با روش فتوالاستیک
Comparison of stresses transferred to the implant supported overdentures with bar, ball and zaag attachments through photoelasticity
General
General
Research
Research
<p align="center"><strong>مقایسه نحوه انتشار نیروها بین سه نوع اتچمنت Bar، Ball و Zaag در اوردنچرهای متکی بر ایمپلنت در فک پایین با روش فتوالاستیک </strong></p><p></p><p align="right"><strong>دکتر ابوالفضل صبوری* - دکتر غلامرضا اصفهانیزاده** - دکتر مسعود اجلالی***</strong></p><p align="right"> *- استادیار گروه آموزشی پروتزهای دندانی دانشکده دندانپزشکی دانشگاه علوم پزشکی شهید بهشتی.</p><p align="right"> **- استادیار گروه آموزشی پروتزهای دندانی دانشکده دندانپزشکی دانشگاه آزاد اسلامی (واحد تهران). </p><p align="right">***- استاد و مدیر گروه پروتزهای متحرک دانشکده دندانپزشکی دانشگاه علوم پزشکی شهید بهشتی. </p><p></p><p align="right"><strong>چکیده</strong></p><p align="right"> <strong>زمینه و هدف:</strong> زمانی که یک دنچر کامل به یک اوردنچر متکی بر ایمپلنت تبدیل میگردد عملکرد جویدن بهبود مییابد و بیشتر اتچمنتهای به کار رفته در اوردنچرها به صورت Bar وBall میباشد که در مورد اثر طراحی و میزان تماس یافتن یک اوردنچر مندیبل بر روی فشارهای وارده به ایمپلنتها نظریات مختلفی وجود دارد. هدف از این مطالعه بررسی و مقایسه نحوه انتشار نیروها در اوردنچرهای متکی بر ایمپلنت در فک پایین با اتصالات Ball،Bar وZaag با روش فتوالاستیک میباشد. <strong>روش بررسی:</strong> روش مطالعه به صورت توصیفی و کارآزمایی آزمایشگاهی میباشد که بر روی مدل فتوالاستیک جهت بررسی نیروهای وارده به ایمپلنت حمایت کننده اوردنچر به همراه اتچمنتهای Ball،Bar وZaag میباشد. محل ایمپلنتها در ناحیه کانینها به فاصله هشت میلیمتر از میدلاین انتخاب شده و نیروهای وارده به میزان Lb30 (معادل نیروهای جونده) به صورت یکسویه بر روی سطح اکلوزال در ناحیه مولر اول در دو حالت افقی و مایل (45 درجه) اعمال گردید. فشارهای ایجاد شده که به بدنه ایمپلنت منتقل شده در زیر تله میکروسکوپ مورد ارزیابی قرار میگیرد. این ارزیابی در هر سه حالت Ball،Bar و Zaag انجام میشود. <strong>یافتهها:</strong> در اوردنچرهای متصل به Bar در حالت اعمال نیروی عمودی هم در ایمپلنت سمت اعمال نیرو و هم در ایمپلنت سمت مقابل نسبت به سایر اتچمنتها، فشار بیشتری ایجاد شد و در حالت اعمال نیرو به صورت مایل میزان فشار بر روی ایمپلنتها نسبت به حالت عمودی بیشتر بود. در مورد اتچمنتهای Ball و Zaag در اثر اعمال نیروی عمودی هم به ایمپلنتها و هم به ریج بیدندانی فشار منتقل شده و در حالت اعمال نیرو به صورت مایل میزان فشار بر روی ایمپلنتها افزایش یافته و برروی ریج بیدندانی هیچ گونه فشاری مشاهده نشد. <strong>نتیجهگیری:</strong> اتچمنت Bar نسبت به اتچمنتهای Ball و Zaag در هر دو حالت اعمال نیروی مایل و عمودی باعث انتقال فشار بیشتری به ایمپلنتها میشود. در مقایسه بین دو سیستمZaag و Ball مشخص شد کهZaag به میزان بیشتری نسبت بهBall باعث انتقال نیرو به بدنه ایمپلنت میشود. </p><p align="right"><strong>کلید واژهها:</strong> ایمپلنت - اوردنچر - اتچمنتهای Ball، Bar، Zaag - فتوالاستیسیته </p>
<p align="center"><strong>Comparison of stresses transferred to the implant supported overdentures with bar, ball and zaag attachments through photoelasticity </strong></p><p></p><p><strong>Dr. A. Saboori* - Dr. Gh. Esfahanizade** - Dr. M. Ejlali***</strong></p><p> *- Assistant Professor of Prosthodontics Dept. - Faculty of Dentistry – Shaheed Beheshti University of Medical Sciences. </p><p>**- Assistant Professor of Prosthodontics Dept. - Faculty of Dentistry – Tehran Islamic Azad University. </p><p>***- Professor and Chief of Prosthodontics Dept. - Faculty of Dentistry – Shaheed Beheshti University of Medical Sciences.</p><p></p><p> <strong>Background and Aim:</strong> When a complete denture is replaced with an overdenture supported by implant, masticatory efficiency will be improved. There are a lot of controversies on the use of the best attachments in overdentures. The aim of this study was to compare the stresses transferred to the implant supported overdentures in mandible with bar, ball and zaag attachments using photoelastic technique. <strong></strong></p><p><strong>Materials and Methods:</strong> In this descriptive in – vitro study, stresses transferred to the implants supported overdentures with bar, ball and zaag attachments were analyzed using photoelastic method. Two implants were installed in the canine area 8 mm from the midline. Vertical and oblique loads of 30Ib were applied to the first molar unilaterally. Resultant stress distribution with ball, bar and zaag attachments were evaluated. <strong></strong></p><p><strong>Results:</strong> The bar attachments exhibited the most stress transferred to the implants on the loaded side and opposite side. When the model was subjected to the posterior vertical load. The oblique load transferred to the implants was more than the vertical load. The ball and zaag attachments transferred the vertical load to both implants and edentulous area. These both attachment systems exhibited more stress on implants in oblique load where as the edentulous ridge was stress free. </p><p><strong>Conclusion:</strong> Bar attachments transferred more stress to the implant bodies than ball and zaag attachments in both oblique and vertical loads and zaag attachments transferred more stress to the implant as compared with the ball ones. </p><p><strong>Key words:</strong> Implant - Overdentures - Attachment - Ball - Bar - Zaag – Photoelasticity </p>
ایمپلنت ، اوردنچر ، اتچمنتهای Ball، Bar، Zaag ، فتوالاستیسیته
Implant , Overdentures , Attachment , Ball - Bar , Zaag , Photoelasticity
66
75
http://jida.ir/browse.php?a_code=A-10-23-2&slc_lang=fa&sid=1
Abolfasl
Saboori
دکتر ابوالفضل
صبوری
Asaboury@yahoo.com
23003194753284600560
23003194753284600560
Yes
Gholam reza
Esfahanizade
دکتر غلامرضا
اصفهانیزاده
23003194753284600561
23003194753284600561
No
Masoud
Ejlali
دکتر مسعود
اجلالی
23003194753284600562
23003194753284600562
No